When the garment factory uses the cloth inspection machine, in this process, due to its own operational errors or equipment quality problems. it may present a condition of equipment failure. This will lead to inaccurate inspections. If it is severe, it will not work directly.and it should not be ignored.It must be dealt with in a timely manner.

The inspection machine in the process of work presents a very noisy scene, which is likely to be caused by factors such as large distance of the drive shaft of the equipment, loose parts of a certain part, and poor lubrication of the oil, as long as the parts are replaced and replaced,The right lubricant is all right. The cloth inspection machine presents the condition that the cloth is stuck during the inspection process. This is probably caused by the skewing of the cloth. It has nothing to do with the quality of the equipment itself. The operator only needs to adjust the guide roller according to the correct method. They are parallel to each other. The glass plate of the cloth inspection machine has low brightness, which is mainly caused by a lot of dust cloth on the glass panel or weakening of the brightness of the light pipe. It is only necessary to regularly arrange the dust cloth and replace the light pipe. The inspection machine does not feel good when the cloth is rolled. The question is likely to be that the transmission direction of the equipment has accumulated a lot of dust, cloth dust, grease, etc., which requires normal maintenance work.